, , ,

W5100 Arduino Ethernet Shield Module Network Expansion Board


Product details

  • Product: Arduino Ethernet Shield
  • Microcontroller: Wiznet W5100
  • Version: latest
  • Dimension: 7cm x 5.4cm x 2.4cm
  • Connection with Arduino: using long wire-wrap headers which extends through the shield

1,275.00 (ex. GST)

Arduino Ethernet shield is based on W5100 ethernet chip which provides a network stack capable of both TCP and UDP. The module allows Arduino to connect with internet without operation system. This ethernet module supports 4 simultaneous socket connection.

RoboElements has the latest version of Arduino Ethernet shield so it has a micro SD card slot and a reset controller. By using the SD card, it stores the data serving over the internet. Reset controller ensures that the W5100 Module is properly reset on power-up.

Features

  • Ethernet shield allows Arduino to connect to the internet
  • Has SD card slot to save data
  • No soldering required to connect with Arduino. Directly plug puzzle board
  • Compatible with all the version of Arduino
  • Connection speed: 10/100Mb
  • No external power needed
  • Arduino communicates with both W5100 and SD card using SPI bus
  • Shield provides standard RJ45 ethernet jack

LED and indication

  1. PWR: Board is powered
  2. LINK: the presence of network and flashes when transmits or receives data
  3. 100M: the presence of 100Mb/s network connection
  4. FULLD: a network connection is a full duplex
  5. COLL: flashes on detection of network collision
  6. RX: flashes when receives data
  7. TX: flashes when transmits data

Instrcutions

  • Ethernet library comes in Arduino 0019
  • SD card library is not yet included in Arduino distribution.
  • W5100 and SD card share SPI bus, so only one can be active at a time
  • While using both peripherals in the programme, corresponding libraries should be taken care of.
  • If one of the peripherals used in the programme, then the maker needs to explicitly deselect it. To do so
    • For SD card: set pin 4 as output and write a high for it
    • For W5100: set digital pin 10 as a high output  

Based on 0 reviews

0.0 overall
0
0
0
0
0

Be the first to review “W5100 Arduino Ethernet Shield Module Network Expansion Board”

There are no reviews yet.

SHOPPING CART

close