PIXHAWK PX4 2.4.8 32-bit Autopilot Flight Controller for Quadcopter and Multicopter

PIXHAWK 2.4.8 autopilot is a general purpose flight controller based on autopilot mega or APM. it is an open source project from 3DR. The flight controller combines the functionality of the PX4MU and PX4IO and strong input control of 32-bit processor. 

This flight controller features with currently most advanced processor technology from STMelectronics, sensor technology from Bosch, InvenSense and a NuttX real-time operating system. Combining all the features, it provides incredible performance, flexibility, and reliability to control any autonomous vehicle, drone or quadcopter. The device has 2 external SPI buses and six associated chip select lines, which allows other sensors to interface. Total it has 4 buses, two for external applications and 2 grouped with serial ports with GPS or compass module. 

Processor

• Main on-board processor: STM32F427 ( 32-bit ARM Cortex M4, with hardware floating point processing unit)
• Main frequency: 256K, 168MHZ RAM
• 32-bit STM32F103 backup coprocessor

Sensor

• L3GD20 3 axis digital 16-bit gyroscope
• LSM303D 3 axis  14 bit accelerometer /magnetometer
• MPU6000 6 axis accelerometer / magnetometer
• MS5611 high precision barometer

Interface

• 5* UART, 1*compatible high voltage, 2*hardware flow control
• 2*CAN
• Spektrum DSM/DSM2/DSM-X satellite receiver compatible input
• Futaba SBUS compatible input and output
• PPM signal input
• RSSI (PWM or voltage) input
• I2C
• SPI
• 3.3 and 6.6VADC input
• External USB MICRO interface

Features

• Advanced 32 bit CortexM4 ARM high-performance processor, can run RTOS NuttX real-time operating the system
• Integrated backup power supply and failure backup controller, the main controller can be safely switched to the backup control
• Provide redundant power input and fault transfer function
• 14* PWM/ actuator output
• Bus interface (UART, I2C, SPI, CAN);
• Provide automatic and manual mode;
• Color LED lamp;
• Multi-tone buzzer interface;
• Micro SD to record flight data;

Package included

• 1 x 2.4.8 Pixhawk main control  
• 1 x Safety switch  
• 1 x Flight control shell
• 1 x Buzzer
• 1 x 6pin to 6pin line  
• 1 x 4Pin to  4Pin line
• 1 x 3pin DuPont line